![]() A good solution would be to put a couple of battens between them at a suitable level to accept the rad brackets. My fear is that someone's going to advise a solution along the lines of "cut a surgical hole out the plaster and from there restructure the entire wall with your pinky and then masterfully skim over it and pretend nothing's happened." This is a bit beyond my skill, I think, so I might have to go for option 4 in this insistence. 1) close the rad valves and take the rad off before it damages the pipes (more) 2) have a look through the hole and see where the studs are. Lots of people seem to advise this, but another miscellaneous man (on a forum this time) said that sometimes very old studs can crack when drilled into?ģ) Use butterfly/molly fixings to just go through the plaster/lath, close your eyes and hope that 6-8 of these across both brackets will be strong enough? First, you’ll repair the lath and then patch the hole. A man in a shop told me this, but I haven't read it on any forums, so I'm not sure whether to trust this miscellaneous "man in a shop".Ģ) Find out where the vertical studs are using a cosmically strong magnet and just fix to this, as normal. If you’re dealing with damaged lath and plaster wallsfor example gaping holes in the wall because of electrical workhere are techniques you can use to repair them. Use extra long screws and fix the brackets to this. Use a dry non-abrasive washcloth to wipe away all the moisture on your wall, using a circular motion again. ![]() Rinse the cloth in warm water, then use it to wipe away any soap residue on the wall. 1) Use an extra long drill bit to go right through to the brick, and then stick in an extra long raw plug that goes through and into the brick and sits facing out the plaster. Rub the area of your wall down with your soapy cloth.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |